Krista / Erica LED Light KitDimmablePatent PendingInstallation ManualBMW K1600GT with CANopener
Page 10Windshield:Remove the 4 bolts securing the windshield.Gas Tank Shroud:In order to remove the gas tank shroud plastics you must flip the plastic
Page 11Step 1: Parts List and Bike PreparationStep 1: DisassemblyDashboard:Remove the 2 bolts holding the speaker covers. In order to get the shroud a
Page 12Gas tank shroud removal continued.Your bike should look like this after removing one side of gas tank shroud plastics. Repeat the above steps f
Page 13Step 2: Mounting The LightsMirror Mount Overview:• To install the Krista / Erica using the supplied mirror mount, remove the mirrors on your b
Page 14Step 2: Mounting The LightsAligning the Lights:Erica and Krista are designed as auxiliary lights, adjustment is up to the user depending on his
Page 15Wire Routing:• Be sure to route wires so that they cannot become tangled or caught in either a suspension part or steering part. Check movemen
Clearwater CANopener operation and featuresSummary of features1. Clearwater Lights dimming feature • Independent dimming of two sets of Clearwater l
Clearwater CANopener operation and featuresDIMMING CONTROL (WonderWheel equipped bikes) Two modulated brightness channels are adjustable using the Wo
Clearwater CANopener operation and featuresHORN ACTIVATION MODEThe Clearwater lights can be programmed for three different modes when the horn button
Clearwater CANopener operation and featuresCLEARWATER BRAKE LIGHT MODULE (OPTIONAL)A 1 AMP driver is provided for the optional Clearwater auxiliary br
Page 2Parts List• Check Parts list below with your kit to be sure all parts are handy. If something is missing please call us at (916) 852-7029.Pleas
The Clearwater Company 11305 Sunrise Gold Cr. Unit D | Rancho Cordova, CA 95742Phone: (916) 852-7029 | Fax: (916) 852-9410 | www.clearwaterlights.comV
Summary of Installation1. Open body panels2. Mount the lights and brackets.3. Disassamble the side panel.4. Remove fuse from Clearwater Lights wir
Summary of CANopener features and operation TSC = Turn Signal Cancel WW = WonderWheel (BMW multifunction controller) FTP = Flash To Pass OBL = Optio
Page 5Mouting CANopener• Remove the seat from the bike and set aside.• Locate the module under the seat, unplug the wiring harness from it and plug
Wiring Diagram “New Install”
Wiring Diagram “Retro-Fit”
Retrofit WiringRetrofit Wiring • Remove the fuse from fuse holder.• Disconnect the connectors from the switch.• Remove the Posi-tap from low beam w
Page 9Step 1: Parts List and Bike PreparationBike Preparation:• First, park the motorcycle on hard pavement or concrete to insure the bike will be st
Comments to this Manuals